Function intel_dp_setup_hdr_metadata_infoframe_sdp handles Infoframe SDP
header and data block setup for HDR Static Metadata. It enables writing of
HDR metadata infoframe SDP to panel. Support for HDR video was introduced
in DisplayPort 1.4. It implements the CTA-861-G standard for transport of
static HDR metadata. The HDR Metadata will be provided by userspace
compositors, based on blending policies and passed to the driver through
a blob property.
Because each of GEN11 and prior GEN11 have different register size for
HDR Metadata Infoframe SDP packet, it adds and uses different register
size.
Setup Infoframe SDP header and data block in function
intel_dp_setup_hdr_metadata_infoframe_sdp for HDR Static Metadata as per
dp 1.4 spec and CTA-861-F spec.
As per DP 1.4 spec, 2.2.2.5 SDP Formats. It enables Dynamic Range and
Mastering Infoframe for HDR content, which is defined in CTA-861-F spec.
According to DP 1.4 spec and CEA-861-F spec Table 5, in order to transmit
static HDR metadata, we have to use Non-audio INFOFRAME SDP v1.3.
+--------------------------------+-------------------------------+
| [ Packet Type Value ] | [ Packet Type ] |
+--------------------------------+-------------------------------+
| 80h + Non-audio INFOFRAME Type | CEA-861-F Non-audio INFOFRAME |
+--------------------------------+-------------------------------+
| [Transmission Timing] |
+----------------------------------------------------------------+
| As per CEA-861-F for INFOFRAME, including CEA-861.3 within |
| which Dynamic Range and Mastering INFOFRAME are defined |
+----------------------------------------------------------------+
v2: Add a missed blank line after function declaration.
v3: Remove not handled return values from
intel_dp_setup_hdr_metadata_infoframe_sdp(). [Uma]
v9: Addressed review comments from Ville.
- Add BUILD_BUG_ON to check a changing of struct dp_sdp size.
- Change a passed size toward write_infoframe() for DP infoframe sdp
packet for HDR static metadata.
Signed-off-by: Gwan-gyeong Mun <gwan-gyeong.mun@intel.com>
Reviewed-by: Uma Shankar <uma.shankar@intel.com>
Signed-off-by: Ville Syrjälä <ville.syrjala@linux.intel.com>
Link: https://patchwork.freedesktop.org/patch/msgid/20190919195311.13972-8-gwan-gyeong.mun@intel.com
When BT.2020 Colorimetry output is used for DP, we should program BT.2020
Colorimetry to MSA and VSC SDP. In order to handle colorspace of
drm_connector_state, it moves a calling of intel_ddi_set_pipe_settings()
function into intel_ddi_pre_enable_dp(). And it also rename
intel_ddi_set_pipe_settings() to intel_ddi_set_dp_msa().
As per DP 1.4a spec section 2.2.4 [MSA Data Transport]
The MSA data that the DP Source device transports for reproducing the main
video stream. Attribute data is sent once per frame during the main video
stream’s vertical blanking period.
In order to distinguish needed colorimetry for VSC SDP, it adds
intel_dp_needs_vsc_sdp function.
If the output colorspace requires vsc sdp or output format is YCbCr 4:2:0,
it uses MSA with VSC SDP.
As per DP 1.4a spec section 2.2.4.3 [MSA Field for Indication of
Color Encoding Format and Content Color Gamut] while sending
BT.2020 Colorimetry signals we should program MSA MISC1 fields which
indicate VSC SDP for the Pixel Encoding/Colorimetry Format.
v2: Remove useless parentheses
v3: Addressed review comments from Ville
- In order to checking output format and output colorspace on
intel_dp_needs_vsc_sdp(), it passes entire intel_crtc_state struct
value.
- Remove a pointless variable.
v9: Addressed review comments from Ville
- Remove a duplicated output color space from intel_crtc_state.
- In order to handle colorspace of drm_connector_state, it moves a
calling of intel_ddi_set_pipe_settings() function into
intel_ddi_pre_enable_dp().
Signed-off-by: Gwan-gyeong Mun <gwan-gyeong.mun@intel.com>
Reviewed-by: Uma Shankar <uma.shankar@intel.com>
Link: https://patchwork.freedesktop.org/patch/msgid/20190919195311.13972-3-gwan-gyeong.mun@intel.com
Signed-off-by: Ville Syrjälä <ville.syrjala@linux.intel.com>
It refactors and renames a function which handled vsc sdp header and data
block setup for supporting colorimetry format.
Function intel_dp_setup_vsc_sdp handles vsc sdp header and data block
setup for pixel encoding / colorimetry format.
In order to use colorspace information of a connector, it adds an argument
of drm_connector_state type.
Setup VSC header and data block in function intel_dp_setup_vsc_sdp for
pixel encoding / colorimetry format as per dp 1.4a spec, section 2.2.5.7.1,
table 2-119: VSC SDP Header Bytes, section 2.2.5.7.5,
table 2-120: VSC SDP Payload for DB16 through DB18.
Signed-off-by: Gwan-gyeong Mun <gwan-gyeong.mun@intel.com>
Reviewed-by: Uma Shankar <uma.shankar@intel.com>
Signed-off-by: Ville Syrjälä <ville.syrjala@linux.intel.com>
Link: https://patchwork.freedesktop.org/patch/msgid/20190919195311.13972-2-gwan-gyeong.mun@intel.com
There was a integer wraparound when mode_clock became too high,
and we didn't correct for the FEC overhead factor when dividing,
with the calculations breaking at HBR3.
As a result our calculated bpp was way too high, and the link width
limitation never came into effect.
Print out the resulting bpp calcululations as a sanity check, just
in case we ever have to debug it later on again.
We also used the wrong factor for FEC. While bspec mentions 2.4%,
all the calculations use 1/0.972261, and the same ratio should be
applied to data M/N as well, so use it there when FEC is enabled.
This fixes the FIFO underrun we are seeing with FEC enabled.
Changes since v2:
- Handle fec_enable in intel_link_compute_m_n, so only data M/N is adjusted. (Ville)
- Fix initial hardware readout for FEC. (Ville)
Changes since v3:
- Remove bogus fec_to_mode_clock. (Ville)
Changes since v4:
- Use the correct register for icl. (Ville)
- Split hw readout to a separate patch.
Signed-off-by: Maarten Lankhorst <maarten.lankhorst@linux.intel.com>
Fixes: d9218c8f6c ("drm/i915/dp: Add helpers for Compressed BPP and Slice Count for DSC")
Cc: <stable@vger.kernel.org> # v5.0+
Cc: Manasi Navare <manasi.d.navare@intel.com>
Link: https://patchwork.freedesktop.org/patch/msgid/20190925082110.17439-1-maarten.lankhorst@linux.intel.com
Reviewed-by: Ville Syrjälä <ville.syrjala@linux.intel.com>
We dont need the definition of the enum port outside I915, anymore.
Hence move enum port definition into I915 driver itself.
v2:
intel_display.h is included in intel_hdcp.h
v3:
enum port is declared in headers.
v4:
commit msg is rephrased.
v5:
copyright year is updated [Tomas]
Signed-off-by: Ramalingam C <ramalingam.c@intel.com>
Reviewed-by: Jani Nikula <jani.nikula@intel.com>
Reviewed-by: Shashank Sharma <shashank.sharma@intel.com>
Reviewed-by: Tomas Winkler <tomas.winkler@intel.com>
Signed-off-by: Uma Shankar <uma.shankar@intel.com>
Link: https://patchwork.freedesktop.org/patch/msgid/20190828164216.405-3-ramalingam.c@intel.com
Move the TypeC port handling functions to a new file for clarity.
While at it:
- s/icl_tc_port_connected()/intel_tc_port_connected()/
icl_tc_phy_disconnect(), will be unexported later.
- s/intel_dp_get_fia_supported_lane_count()/
intel_tc_port_fia_max_lane_count()/
It's used for HDMI legacy mode too.
- Simplify function interfaces by passing only dig_port to them.
No functional changes.
v2:
- Fix checkpatch issues: +1/-1 empty lines in intel_tc.c and add
missing SPDX to intel_tc.h. (Jani)
Cc: Animesh Manna <animesh.manna@intel.com>
Cc: Paulo Zanoni <paulo.r.zanoni@intel.com>
Cc: José Roberto de Souza <jose.souza@intel.com>
Cc: Jani Nikula <jani.nikula@intel.com>
Signed-off-by: Imre Deak <imre.deak@intel.com>
Acked-by: Jani Nikula <jani.nikula@intel.com>
Reviewed-by: José Roberto de Souza <jose.souza@intel.com>
Link: https://patchwork.freedesktop.org/patch/msgid/20190628143635.22066-4-imre.deak@intel.com
Add a new subdirectory for display code, and start off by moving
modesetting output/encoder code. Judging by the include changes, this is
a surprisingly clean operation.
v2:
- move intel_sdvo_regs.h too
- use tabs for Makefile file lists and sort them
Cc: Chris Wilson <chris@chris-wilson.co.uk>
Cc: Joonas Lahtinen <joonas.lahtinen@linux.intel.com>
Cc: Rodrigo Vivi <rodrigo.vivi@intel.com>
Cc: Ville Syrjälä <ville.syrjala@linux.intel.com>
Reviewed-by: Chris Wilson <chris@chris-wilson.co.uk>
Acked-by: Rodrigo Vivi <rodrigo.vivi@intel.com>
Acked-by: Maarten Lankhorst <maarten.lankhorst@linux.intel.com>
Acked-by: Ville Syrjälä <ville.syrjala@linux.intel.com>
Signed-off-by: Jani Nikula <jani.nikula@intel.com>
Link: https://patchwork.freedesktop.org/patch/msgid/20190613084416.6794-2-jani.nikula@intel.com
2019-06-17 11:25:06 +03:00
Renamed from drivers/gpu/drm/i915/intel_dp.h (Browse further)
